Technical data

t [phone] e [e-mail] w www.mwatechnology.com t [phone] e [e-mail] w www.mwatechnology.com
62 63
SIGN UP TODAY
AND GET YOUR FREE COPY
Simply email us requesting your copy and we
will post you a copy out or if you prefer, we can
send you an electronic copy every quarter.
aPRODUCT LAUNCHES
aMETER REVIEWS
aEXHIBITION DATES
aNEW TECHNOLOGY
aINDUSTRY COMMENT
READ ALL
ABOUT
IT...
e [e-mail]
lPre-alarm LED signal when below the L.E.L
lInternal audible alarm
lAutomatic gas solenoid valve shut off
lContinual sensor diagnostic tests
lFault indication
lMute override for 10 minutes
P60 STAND ALONE GAS DETECTOR
A high sensitivity sensor for the detection of gas concentration. The stand alone gas detector is available in two
models. P60 for use on natural gas detection and the P60 used for LPG and cylinder liquid gas.
lVisual LED indication for three separate zones
lInternal audible alarm
lAdjustable alarm time delay
lIP40 protection
lWall or panel front mounting
lInsulated enclosure
3 ZONE GAS DETECTION
The P30 gas detection electronic control centre is used for the detection of gas within industrial environments.
Natural gas, town gas, LPG and cylinder gas can be detected using the various sensors available. This unit will
provide gas detection for three separate zones.
lTwo SPDT relays for use of closing the
gas solenoid valve and BMS alarms
lAlarm delay setting - up to 60 seconds
lComplies with CEI EN 60730-1 standards
l230v 50Hz or 12vDc
GAS DETECTION
4 ZONE GAS DETECTION
The P82 gas detection electronic control centre is used for the detection of gas within
industrial environments. Natural gas, town gas, LPG and cylinder gas can be detected
using the various sensors available.
DETECTION HEADS
These gas sensor heads are to be used with either P30 or P82 gas detection units. There are two types available, the
S81 for natural gas and light gas, the S82 for LPG heavy gases. The sensor for alarm is set below the L.E.L level (Lower
Explosion Limit) however there is internal regulation for the sensitivity if required.
lVisual LED indication for four separate zones
lInternal audible alarm
lAdjustable alarm time delay
lDin Mounting
lInsulated enclosure
lGreen LED for power on indication
lRed LED for gas presence indication
lAmber LED for fault indication
lAnti-shock casing material
lIP54
lInsulated shock resistant enclosure
lComplies with UNI CEI 70028 standards
lIMQ homologation
l230v 50Hz
lTwo SPDT relays for use of closing the gas
solenoid valve and BMS alarms
lAlarm delay setting - up to 60 seconds
lComplies with CEI EN 60730-1 standards
l230v 50Hz