User's Manual

DIMENSIONAL DRAWING

8-1/2"

(216MM)

8-15/16"

(227mm)

6-5/8"

(168mm)

TROUBLESHOOTING

All lights are thoroughly inspected before shipping and are warranted to ope

AND WIRE HARNESS CONNECTIONS BEFORE PROCEEDING WITH THI

PROBLEM

Control lever works in reverse in all directions.

Light moves in only three of the possible four directions.

Dim light (low voltage)

Bulb operates - no light movement

Light moves - bulb does not operate.

FCC REGULATIONS

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may not

cause harmful interference. (2) This device must accept any

interference received, including interference that may cause

undesired operation. Note: The manufacturer is not responsible for

any radio or TV interference cuased by unauthorized modifications

to the equipment. Such modifications could void the user's authority

to operate the equipment.

Note:This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment gen-

erates, uses and can radiate radio frequencey energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

Dimensional Drawings