Instructions

HD32.8 - 27 - V1.3
WARNING! When the instrument is locked by a password, all keys are locked, except MEM, used
to start the LOG session (data capture) and SETUP, ENTER and ESC that allow entering the main
menu to unlock the instrument.
Therefore the user has to first set all required parameters, protect the instrument using the
KEY LOCK function and start the LOG session, in order to prevent any undesired access by
unauthorized personnel.
To unlock the instrument, repeat the steps above: Enter the main menu and unlock the instrument
using the Key lock item and entering the password.
If the password is wrong, you will get the message “Wrong password”. The default password is
“0000” (four zeroes).
4.10 PASSWORD
This menu item allows to set a password to protect the instrument from unauthorized access. There
are two types of available passwords, both consisting of four characters:
• The user password: Can be set by the user to protect the instrument from unauthorized access;
• The factory password: Reserved to Technical Support
To access the Password submenu, proceed as follows:
1. Press SETUP;
2. Use the arrows ▲▼◄► to select Password;
3. Press ENTER;
4. You will get the following message
5. Use the arrows ▲▼ to select User password;
6. You will get the message “Insert old password” The default password is “0000” (four zeroes).
7. Use the ▼▲ arrows to enter the current password;
8. Press ENTER to confirm (or ESC to cancel);