Instructions

HD32.8 - 24 - V1.3
data printing is started when the PRINT key is pressed. Press PRINT again to end the continuous
printing.
Select a sufficiently long print interval so that the printer connected to the instrument can actually
perform the printing.
4.4 RESET
To restore the factory settings, reset command was designed for a complete reset of the instrument.
To access the Reset submenu, proceed as follows:
1. Press SETUP;
2. Use the arrows ▲▼ to select Reset;
3. Press ENTER: You will get the following message
4. Use the arrows ▲▼ to select Reset;
5. Press ENTER to confirm, or ESC to exit the submenus without resetting the instrument;
6. Press SETUP to exit immediately from the main menu.
4.5 CONTRAST
This menu item allows increasing or decreasing the contrast on the display.
To access the Contrast submenu, proceed as follows:
1. Press SETUP;
2. Use the arrows ▲▼ to select Contr.;
3. Press ENTER;
4. You will get the following message
5. Use the arrows ◄► to decrease or increase the contrast;
6. Press ENTER or ESC to return to the main menu;
7. Press SETUP to exit immediately from the main menu.