Instructions

HD32.8 - 22 - V1.3
The memory can be handled in two modes that can be selected using the ▲▼ arrows:
• Circular memory. When the memory is full, the new files will overwrite the oldest ones.
• Until memory full. When the memory space is full, the recording will stop and the message
“WARNING: MEMORY FULL!!” will be displayed. In order to continue recording, the files in
the memory should be erased.
1. Press ENTER to confirm the selected mode;
2. Press ESC to cancel the operation and return to the previous menu level;
3. Press SETUP to exit immediately from the main menu.
4.3 SERIAL MENU (SERIAL COMMUNICATION)
The Serial submenu allows setting the data transfer speed via the serial port (Baud rate), and the
record printing interval (Print Interval).
The LOG sessions can be downloaded on a PC, through the serial RS232 or USB connection.
In case of serial connection, the transfer speed can be set by the user (see next par.) up to a
maximum of 38400 baud.
In case of USB connection, the transfer speed is fixed at 460800 baud.
The data downloaded to the PC using the DeltaLog9 software (vers. 3.0 and later) can be displayed
as a table or graphically.
The instrument can be connected directly to a printer with serial input.
To access the Serial submenu, proceed as follows:
1. Press SETUP;
2. Use the arrows ▲▼◄► to select Serial;
3. Press ENTER;
4. You will get the Serial submenu.