Instructions

HD2402 - 20 - V1.3
(hh:mm:ss). Select the Apply key to save the instrument settings, logging will auto-
matically start at the set date/time. The instrument can also be disconnected from the
PC and connected to the power supply unit. The rear LED blinks every 3 seconds until
acquisition is started; the Led will start blinking once per second from the moment ac-
quisition is started.
Manual logging in the instrument memory is started by selecting the Start Logging
icon (or in alternative by pressing the rear button for 5 seconds).
After logging startup, the Start Logging icon is replaced by the Stop Logging icon. To
manually stop logging, select the Stop Logging icon (or in alternative press the rear
button for 5 seconds). Data are saved in the Monitor folder in the predefined folder;
the file will be identified by the logging start/stop time
Logging can be manually started and automatically stopped by setting the Duration of
Logging field (hh:mm:ss) in the Auto-Start Logging window. In this case, the Auto-
start enable box must not be selected.
Note: before starting logging, make sure that the instrument date/time are correct, by
selecting the Instrument Setup icon and then the Clock Setting item.
6.3 DOWNLOAD OF THE MEASUREMENTS STORED IN THE PC
If data have been logged in the instrument internal memory, they must be down-
loaded to a PC for analysis.
Connect the instrument to a PC, start DeltaLog13 and wait for automatic detection of
the instrument. Select the Dump LOG icon.
A list of the files stored in the instrument memory will appear.
The start/stop time for each log is displayed. Select logs to be downloaded and press
the Dump LOG icon. Data are saved in the Logging folder, in the predefined folder;
files will be identified by the logging start/stop time.