Instructions

HD2402 - 19 - V1.3
In case of doubt, it is advisable to select the AUTO setting, leaving to the instrument
the most appropriate choice to use.
Once a new scale is set, the Apply key must be pressed to activate the change. When
pressing the Apply key, the setting of inputs is saved in the instrument and will re-
main active even if the instrument is subsequently disconnected.
If a channel measurement is beyond full scale, the corresponding indicator in the col-
umn Ovf will appear in red color.
6.2 LOGGING MODE
It is possible to select if to directly log measurements in a PC or in the external mem-
ory of the instrument.
PC data logging can only be started manually by selecting the Start PC Log icon.
In this case, the instrument will necessarily have to remain connected to the PC dur-
ing data logging. After logging startup, the Start PC Log icon is replaced by the Stop
PC Log icon. To stop logging, select the Stop PC Log icon. Data are saved in the Moni-
tor folder in the predefined folder; the file will be identified by the logging start/stop
time.
Data logging in the instrument memory can be started in a programmed way or ma-
nually. To set the programmed log, select the Instrument setup icon and then the
Logging setting item. The following window will appear:
Select the Auto-Start enable box, set logging start date/time in the Auto-Start Log-
ging line (start time must be subsequent to the current time indicated in the PC Clock
line by at least 20 minutes), set log duration in the Duration of Logging field