Instructions
- -
40
• Some keys are disabled during logging. The following keys are enabled: MEM, MENU, ENTER
and ESC.
• Pressing the MEM and MENU keys has no effect on the logged data if these keys are pressed
after starting the recording, otherwise the following is valid.
5.1.3 Print function
Press ENTER to send the measured data directly to the USB port, in real time. The printed data
units of measurements are the same as those used on the display. The function is started by pressing
ENTER.
The time interval between two consecutive prints can be set from 15 second to 1 hour (please see
the Print interval menu item at par. 4.3.1 Print Interval). If the print interval is equal to 0, by
pressing ENTER a single data is sent to the connected device. If the print interval is higher than 0,
the data transfer continues until the operator stops it by pressing ENTER again.










