Instructions

- -
18
4.2.2 AutoPowerOff– AutoPowerOff Mode
The Auto switch off item controls the instrument’s automatic turning off during logging, between
the capture of a sample and the next one. When the interval is lower than 5 minutes, the
instrument will always remain on. With intervals greater than or equal to 5 minutes, it is possible
to turn off the instrument between loggings: it will turn on one minute before sampling and will turn
off immediately afterwards, thus increasing the battery life.
Once you have accessed the LOGGING submenu (previous paragraph) use the arrows ▲▼ to
select Auto switch off. During configuration, the following is displayed:
• If the set Log Interval (see previous par.) is lower than 5 minutes, the following will be
displayed
LOGGING MENU
AUTO SWITCH OFF
Logging frequency
setted < 5 min.
During log session
the instrument
will shut ON
between two samples
<ESC> exit/cancel
If the set Log Interval (see previous par.) is greater or equal to 5 minutes, the following will be
displayed during configuration:
LOGGING MENU
AUTOPOWEROFF
Logging frequency
setted >= 5 min.
During log session
the instrument
will shut OFF
between two samples
▲▼ set
<ESC> exit/cancel
1. By using the arrows ▲▼ you can select:
ON (the instrument stays on)
OFF (the instrument stays off)
2. Press ESC to return to the Logging menu;
3. Press ESC again to return to the main menu;
4. Press MENU to exit immediately from the menu.