Instructions

- -
16
To change the ID, press ENTER. Use the ◄► arrows to select the item, and edit it with the ▲▼
arrows. Proceed with the other items, and finally confirm with ENTER.
By selecting Info Sensors, the following information on the sensors will be displayed:
INFO SENSORS
Type= CO2-CO Fw.V0R0
Cal = 2010/02/10
SN = 10010000
INFO SENSORS:
Firmware type and version.
Calibration date.
Serial number of the sensors board.
Press ESC to return to the main menu. Press MENU to exit the menu.
Time/Date allows setting the date and time that will be shown at the top of the display.
To access the Time/Date submenu, proceed as follows:
1. Use the arrows ▲▼ to select Time/Date;
2. Press ENTER;
3. You will get the following message
TIME / DATE
year/mm/dd hh:mm
2010/02/10 08:00:00
set 00 seconds!
◄► select
▲▼ set
<ENTER> confirm
4. Use the arrows ◄► to select the data to be set (year/month/day and hour:minutes);
5. Once selected, the data will start blinking;
6. Use the arrows ▼▲ to enter the correct value;
7. Press ENTER to confirm and return to the main menu;
8. Or press ESC to return to the menu without making any change;
9. Press MENU to exit immediately from the main menu.
NOTE: In regard to the time, you can set hours and minutes. The seconds are always set to 00 (set
00 seconds!).