Data Sheet

7
Example of a PDF report - Graphs
In the graphs are shown in gray the areas of alarm (values that exceed the thresholds set).
The time required to generate the PDF file depends on the amount of data acquired, and can go from a few seconds (if the amount of data acquired is limited) up to about a
minute.
Note: the PDF report is generated with the data stored in the Flash memory; the number of samples in the Flash memory may be less than the number of samples stored in the
CSV file (please see the memory capacity in the specifications table).
The generation of the PDF report can be enabled/disabled by using the HD35AP-S application software or, alternatively, by holding pressed the STOP button and then pressing
the reset button located on the electronic board (above the battery connector).