User's Manual
VCB-5003L6-W User Manual
6
valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for reevaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end
product must be labeled in a visible area with the following: “Contains FCC ID: 2AMVP-
VCB5003L6W” and “Contains FCC ID: XMR201707BG96”. The grantee's FCC ID can be
used only when all FCC compliance requirements are met.
The following FCC part 15.19 statement has to also be available on the label:
This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user’s manual of the end product which integrates
this module.
In the user manual of the end product, the end user has to be informed that the equipment
complies with FCC radio-frequency exposure guidelines set forth for an uncontrolled
environment.
The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment.
The end user manual shall include all required regulatory information/warning as show in this
manual.
The maximum operating ambient temperature of the equipment declared by the manufacturer
is: -20~+70°C
Installation Guideline
Antenna information
Certified antenna: Delta model: WTTX-D24002SMA137150-180310B Max gain 2 dBi
Other antenna(s) need to be certified before use with this module.