User's Manual

802.11b/g WiFi Module
Region Define the regulatory domain of the operation area (default: US)
Firmware Version 2.6.4.0
IP Address Assign Internet Protocol (IP) address to the access point.
Subnet Mask Assign IP Subnet Mask to the access point.
Default Gateway Assign default Gateway to the access point if needed
DHCP Client Dynamic Host Configuration Protocol, it allows to request the IP from DHCP
server for all wireless clie nts.
Wireless Network Name (SSID) Enter a 32-character (maximum) extended service set ID in this field. The
characters are case sensitive. With an access point, the wireless network
always functions in infrastructure mode. The SSID assigned to the wireless
nodes in the same network is required to match the access point SSID. The
default SSID is “default.
Channel In infrastructure mode, the wireless node automatically searches through all
available wireless channels for an access point to be associated with. It is
not necessary to select the wireless channel when operating in infrastructure
mode. The default wireless channel is 1.
Encryption Type Show encryption type OFF, WEP, 802.1X, or WPA.
Access Control Show Access Control Enable, Disable or Block
Setup
.
IP Setting
IP Settings MODEL ProST WLAN ACCESS POINT
Name The default Access Point Name is located on the bottom label of the product. You may
modify the default name with a unique name up to 15 characters long.
DHCP client When there is DHCP Server on the network, if you will manually configure this device,
check the Disable check box. Otherwise, check the “Enable” check box, and you need
enter the next three items below correctly.
IP Address Assign Internet Protocol (IP) address to the access point.
IP subnet mask Assign IP Subnet Mask to the access point.
Default Gateway Assign default Gateway to the access point if needed
Spanning Tree Protocol Spanning-Tree Protocol is a link management protocol that provides path redundancy
while preventing undesirable loops in the network. You can enable it to gain the
function.