User's Manual

802.11b/g WiFi Module

Advanced Configuration
Allow advanced users to set up RTS (Request to Send) Threshold packet size, Fragmentation Packet Length, Beacon
Interval, VSS, VLAN, snmp trap, time protocol and so on.

Wireless Settings
Advance Wireless Setting Model ProST WLAN Access Point
dot11OperationalRateSet It specifies the set of data rates at which the station may transmit data. Each octet
contains a value representing a rate. Each rate shall be within the range from 2 to 127,
corresponding to data rates in increments of 500 kb/s from 1 Mb/s to 63.5 Mb/s, and
shall be supported for receiving data.
dot11BeaconPeriod Specify the value for Beacon Interval. You can choose it between 1 and 65535.
dot11RTSThreshold The packet size that the wireless node uses to determine if it should use the
CSMA/CD mechanism or the CSMA/CA mechanism for packet transmission. With
the CSMA/CD transmission mechanism, the transmitting station sends out the actual
packet as soon as it has waited for the silence period. With the CSMA/CA
transmission mechanism, the transmitting station sends out a RTS packet to the
receiving station, waits for the receiving station to send back a CTS packet before
sending the actual packet data. You can choose it between 0 and 2347.
dot11FragmentationThreshold
This is the packet length used for fragmentation Packets large
r than the size