User Manual

AT-TQ 2403 IEEE 802.11abgh, D ual Radio, Enterprise W ireless Access Point Installation Guide 19
Figure 10: Kick Start W elcome Page
3. Click N ext to search for access points. W ait for the search to complete, or until Kick Start has found
your new access points, as shown in Figure 11.
Figure 11: Kick Start Search Results Page

N ote: The Kick Start utility only finds AT-TQ 2403 IEEE 802.11abgh, D ual Radio, Enterprise
W ireless Access Point.
If Kick Start does not find the AT-TQ 2403 IEEE 802.11abgh, D ual Radio, Enterprise W ireless Access
Point you just installed, an informational window is displayed with troubleshooting information about
your LAN and power connections.
4. Review the list of access points that Kick Start found, as shown in the example in Figure 12.
The access points are listed with their locations, media access control (MAC) addresses, and IP
addresses. If you are installing the first access point on a single-access-point network, only one entry is
displayed on this page.
5. Verify the MAC addresses against the hardware labels for each access point. This will be especially
helpful later in providing or modifying the descriptive Location name for each access point.
6. Click N ext. The Administration dialog box opens, as shown in Figure 12.