User Manual

AT-TQ 2403 IEEE 802.11abgh, D ual Radio, Enterprise W ireless Access Point Installation Guide 17
Connecting the Access Point to the LAN
To connect the AT-TQ 2403 IEEE 802.11abgh, D ual Radio, Enterprise W ireless Access Point to the LAN ,
perform the following procedure:
1. Locate the RJ45 cable in the box.
2. Connect one end of the cable to the LAN .
3. Connect the other end of the cable to the LAN port on the back of the access point, as shown in
Figure 7.
Figure 7: Attaching the LAN Cable
Powering On the Access Point
To power on the access point, perform the following procedure:
W arning: D o not work on equipment or cables during periods of lightning activity.
W arning: Power adapter is used as a disconnection device. To de-energize equipment,
disconnect the power adapter.
1. Do one of the following:
a. Plug the power adapter on the back panel, as shown in Figure 8, and plug the power adapter into
a wall outlet.
Figure 8: Connecting the Power Adapter
b. Plug a LAN cable from a unit that supports PoE into the LAN port, as shown in Figure 9. N o other
power connection is required.

N ote: Please be aware that a metal surface acts as a shield for radio signals. Therefore expect
little or no coverage at all behind metal surface.