1Mbps Wireless Access Point Quick User Guide Package Contents WLAN Access Point 5V@800mA power adapter USB Cable Ethernet Cable Quick User’s Guide
Frequency Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Setting the IP Address of the Access Point The first step in using the WLAN Access Point is to set its IP Address. In order to set the Access Point IP address users use the Bridge Utility Application via USB port. Before executing the Bridge Utility Application, user needs to install USB driver. How to Install the USB driver 1. Plug the Access Point USB port into the USB port of a notebook or desktop PC. 2.
Access Point Configuration The Access Point Configuration can be done either through the Ethernet port by using the SNMP Manager application, or the USB port by using the Bridge Utility application. In order to configuration the Access Point through the Ethernet port, users must first install the SNMP Manager application, which is a tool used for the remote configuration of the Access Point through the Ethernet port. How to Install the SNMP Manager 1. Find the “SNMPManager.
Using the SNMP Manager when users do not know the IP address 1. On the Start menu, Select SNMP Manager. 2. Select “Find Access Point” option on the “File” menu. 3. The available Access Points are listed on the windows. 4. Select one of the available Access Points and press “Connect”. 5. Users are ready to do the configuration.
Using the USB Port 1. Plug USB Cable into the USB port of the Access Point. 2. Run the Bridge Utility Application (DFU utility). 3. Browse for the file “bridge.rom”. 4. Press the “Download” button.
