User Manual

Wireless PCMCIA card
iii
Warning:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user authority to operate the equipment.
CAUTION:
This device is intended only for OEM integrators under the
following conditions:
1. This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna (installed to
end product) shall not be less than 20 cm (8 inches) during
normal operation.
2. This Transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter
As long as the 2 conditions above are met, further transmitter
testing will not be required. However, the OEM integrator is
still responsible for testing their end-product for any additional
compliance requirements required with this module installed
(for example, digital device emission, PC peripheral
requirements, etc.).
Additional Information that Must be Provided to OEM
Integrators:
The end user should NOT be provided any instructions on how
to remove or install the device.
Wireless PCMCIA card
iv
IMPORTANT NOTE.
1) In the event that these conditions can not be met (for
example certain laptop configurations or co-location with
another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
2) To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with
any other antenna or transmitter."
End Product Labeling
This transmitter module is authorized only for use in devices
where the antenna may be installed such that 20 cm may be
maintained between the antenna and users (for example access
points, routers, wireless ASDL modems, and similar
equipment). The final end product must be labeled in a
visible area with the following: "Contains TX FCC ID:
PD5LMWP210RB
Technical Support
DELTA PRODUCTS CORPORATION
5105 Davis Dr. y P.O. Box 12173
Research Triangle Park, NC 27709
Internet: http://www.deltaww.com
Tel: [phone]
Fax: [phone]
E-mail: [e-mail]