User's Manual

Specifications
Mechanical
Dimensions (antenna stowed) (HxWxD) :
• 107mm x 184mm x 32mm
• 4.21” x 7.24” x 1.26”
Weight - 0.45Kgs / 0.99Lbs
Temperature:
• Operating: 0ºC to 50ºC (32ºF to 122ºF)
• Storage: -10ºC to 70ºC (14ºF to 158ºF)
Relative Humidity - 5% to 90% non-condensing
Altitude - 8,000ft @ 28ºC (82.4ºF)
Mounting:
• Wall, cube or ceiling mountable
• Enclosure supports integrated wall point / screw head
mounting lugs (screw head 7mm diameter maximum)
Antenna - Integrated, non-detachable articulating
dual-band antenna
Visual Status Indicators (LEDs):
• PWR - Power / Status
• ENET - Ethernet link status / Activity
• WLAN G - WLAN 2.4GHz status / Activity
• WLAN A - WLAN 5GHz status / Activity
Electrical
Ethernet:
• 1 x 10/100 Base-T auto-sensing Ethernet RJ-45 Interface,
MDI/MDX
• IEEE 802.3af compliant Power Over Ethernet
• IEEE 802.3, IEEE 802.3u
• Power Over Ethernet (IEEE 802.3af compliant), 48V DC /
200mA (see Ethernet pin-out diagram for pin confi guration)
• Reset button
Wireless LAN
Network Standards - IEEE 802.11b, IEEE 802.11g and
IEEE 802.11a
Antenna Type - Integral, 802.11a/b/g omni-directional
high-gain antenna
Antenna Gain:
• 2.4 ~ 2.5GHz / 2.11dBi
• 4.900 ~ 5.850 GHz / 2.07dBi
Radio Technology:
• Orthogonal Frequency Division Multiplexing (OFDM)
• Direct Sequence Spread Spectrum (DSSS)
Radio Modulation Type:
• 802.11b - CCK, BPSK, QPSK
• 802.11g - CCK, BPSK, QPSK,16-QAM, 64-QAM
• 802.11a - BPSK, QPSK,16-QAM, 64-QAM
Media Access Control - CSMA/CA with ACK
Supported Frequency Bands 2.4GHz:
• 2.400 ~ 2.4835GHz (Global), channels country specifi c
Supported Frequency Bands 5GHz:
• 5.150 ~ 5.250GHz (low band), country specifi c
• 5.250 ~ 5.350GHz (mid band), country specifi c
• 5.470 ~ 5.725GHz (Europe), country specifi c
• 5.725 ~ 5.825GHz GHz (high band), country specifi c
Operating Channels:
802.11b 802.11g 802.11a
• US, Canada 11
• ETSI 13
• Japan 13
• US, Canada 11
• ETSI 13
• Japan 13
• US, Canada 12
• ETSI (up to 19)
• Japan 4
Complete country list available at http://www.arubanetworks.
com/products/aps/certifi cation
Data Rates:
• 802.11b - 1, 2, 5.5, 11 Mbps per channel
• 802.11g - 6, 9, 12, 18, 24, 36, 48 and 54 Mbps per
channel
• 802.11a - 6, 9, 12, 18, 24, 36, 48 and 54 Mbps per
channel
Output Transmit Power - 100 mW maximum (or lower as confi g-
ured on the Aruba Mobility Controller to comply with local regula-
tory requirements)
Miscellaneous Functionality
Maximum Clients - 64
Radio Band Selection - via Mobility Controller in software
Manageability:
• Management of all 802.11 parameters
• Network Wide AP Management via CLI, WEB GUI and
SNMPv3
• Access Point Profi les, managed by Geographical Location,
BSSID and Radio Type
Encryption (AP and Mobility Controller) - 40bit / 64bit / 128bit /
152bit WEP, TKIP, AES
Compliance
FCC
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifi cations not expressly approved by the
party responsible for compliance could void the user’s authority
to operate this equipment.
This product complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
CAUTION STATEMENT: FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set
forth for indoor use only. This equipment should be installed and
operated with a minimum distance of 20 centimeters (7.87 inches)
between the radiator and your body for 2.4 GHz and 5 GHz opera-
tions. This transmitter must not be co-located or operating in con-
junction with any other antenna or transmitter.
This device is restricted to indoor use due to its operation in the
5.15 to 5.25 GHz frequency range. The FCC requires this product
to be used indoors to reduce the potential for harmful interference
to co-channel Mobile Satellite systems. High power radars are
allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to
5.85 GHz bands. These radar stations can cause interference with
and/or damage this device.
Canada
This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus as set out in the interference-
causing equipment standard entitled “Digital Apparatus,” ICES-003
of the Department of Communications.
Cet appareil numérique respecte les limites de bruits radioélec-
triques applicables aux appareils numériques de Classe B prescrites
dans la norme sur le matériel brouilleur: “Appareils Numériques,”
NMB-003 édictée par le ministère des Communications.
VCCI - Class B
CE - Class B
Warning—This is a Class B product. In a domestic environment,
this product may cause radio interference in which case the user
may be required to take adequate measures.
EU - Class B
This product complies with EN5022 Class B and EN5024
standards.
Certifications
Electromagnetic Compatibility
FCC Part 15 subpart C (15.247/15.407
RSS 210 (CAN)
TELEC ARIB STD-T66
EN 61000-4-2, EN 61000-4-3, EN 61000-4-4,
EN 61000-4-5, EN 61000-4-6, EN 61000-4-11
EN 60601-1-2: 2001
73/23/ECC
AS/NZS 4268 Class B
The CE approval mark on back of the product indicates that
it meets R&TTE Directive - EN 300 328, EN 301 489, EN 301
893
Safety
UL Listed (UL60950)
UL Listed (Canadian Electrical Code/CSA 22.2 No. 60950)
EN60950 / IEC60950
Disposal of AP40/41
When the useful life of the Access Point has expired, be sure
to dispose of the unit in accordance with all local code and
environmental regulations. Contact your local waste man-
agement or environmental agencies for details.
Customer Support
Main Site: www.arubanetworks.com
Support: www.arubanetworks.com/support
E-mail
Sales: [e-mail]
Support: [e-mail]
Telephone Numbers
Main 408-227-4500
Fax [phone]
Sales 408-754-1201
Support In the U.S.: 800-WI-FI-LAN (800-943-4526)
International: 408-754-1200
1322 crossman avenue sunnyvale california 94089
tel [phone] fax [phone]
www.arubanetworks.com
B