Installation manual

8 Operation and installation manual SOLIVIA Gateway M1 G2

7 Installation Procedure

7.1 Registration

First register for a SOLIVIA Monitor user account on the web at: http://monitoring.solar-

inverter.com. After registering you will receive a conrmation email including a link to

activate your user account. After the activation of your user account go to

http://monitoring.solar-inverter.com and login to setup your PV installation at the moni-

toring portal (only the plant and the gateway are needed, the inverter will be created

automatically). Complete the PV installation setup before installing the monitoring hard-

ware. In this way, you can go to the web portal after the hardware installation and verify

everything is working correctly.

NOTICE

At the install site, verify the internet connection is active by connecting a laptop to the

internet connected network point and pointing a web browser to www.solar-inverter.

com.

7.2 Mounting

Mount the SOLIVIA gateway with the appropriate AC power location specied in Chap-

ter 5.2. You have either the possibility to mount the SOLIVIA gateway on a DIN rail or

directly to the wall.

7.2.1 Mounting on a DIN Rail

The gateway can be mounted on the following DIN Rails:

• DIN Rail according to EN60715 TH35-15

• DIN Rail according to EN60715 TH35-7.5

The gateway should be installed horizontally with connectors on the bottom.

To mount, snap the gateway on the DIN rail as shown in Figure 1:

1. Pull the gateway's DIN rail latch OUT.

2. Tilt the unit slightly upwards, hook the top end onto the DIN rail and push down-

wards until stopped.

3. Position the bottom front end against the DIN rail until it has snapped onto the DIN

rail.

4. Push the gateway's DIN rail latch IN to lock.

Figure 1: Mounting the gateway on a DIN rail