Installation manual
67
Operation and Installation Manual for SOLIVIA 2.0/2.5/3.0/3.3/3.6/5.0 EU G4 TR
11. Saving and Loading Data and Settings
EN
11.6 Saving Swap Data
NOTE
In this chapter, the term "swap" means the
replacement of a solar inverter with a new device
of the same type, without changing the installa-
tion parameters, e.g., those of the PV modules.
The replacement may only be performed after
consulting Delta Solar Support. The support team
will discuss the correct procedure with you.
The following information is saved:
● Grid settings
● User settings
● Display settings
● Production settings
● RS485 ID
● Statistics
● Date of rst installation
➔
USB features
Options
Install settings
-------------------
Production info
SOLIVIA ##
1. In the main menu, press the buttons to select USB
features and then press the
button.
→ A note on IP65 protection is then displayed.
protection.
will lose the IP65
Without cover, you
2. Press the button to conrm.
→ The 300 USB features menu is then displayed.
➔
Save settings
Save swap data
Firmware update
-------------------
300 USB features
3. Press the buttons to select Save Swap Data and
then press the
button.
→ The data is saved in a "SWAP_###.CFG" le on the
USB drive. The ### characters represent the RS485
ID of the solar inverter from which the data is to be
loaded, for example "001".
NOTE: If the message Pendrive
error is displayed, make sure the
USB drive is properly inserted.
Press ENTER
Successful
Save data
4. Press the button to conrm.