Installation Notice
Table Of Contents
- Symbols Used 5
- General Safety Information 6
- Qumi Z1H Installation Notice 6
- Power Supply Safety 7
- Cleaning Qumi 7
- Control Warning 7
- FCC Warning 8
- Canada 8
- Safety Certifications 8
- Disposal and Recycling 8
- About this Manual 9
- Qumi Z1H Main Features 9
- Front-Left View 11
- Rear View 11
- Top View 12
- Bottom View 13
- Remote Control Keypad 14
- Activating the Remote Control Battery 15
- Replacing the Remote Control Battery 15
- Powering On/Off the Projector 17
- Connecting to a Wi-Fi Network 20
- Adjusting the Focus 23
- Playing Media Files from a Storage Device (USB Flash Drive, microSD Card) 24
- Screencasting with a Mobile Device 28
- Playing from a Video Source (HDMI) 29
- Playing from a Video Source (Type-C / DisplayPort) 30
- Viewing Documents from a Storage Device (USB Flash Drive, microSD Card) 31
- Using the Bluetooth® Speaker 33
- Connecting the Projector to Bluetooth Devices 35
- Customizing the App Shortcuts on the Home Screen 38
- Customizing the Category Menus 39
- The Projector Settings Menu 40
- The System Settings Menu 42
- Tips 46
- System Reset Method (Reboot) 46
- Image Problems 47
- Remote Control Problems 47
- Audio Problems 47
- FAQs 48
- Vivitek Support Site 49
- Projection Distance vs Projection Size 50
- Timing Mode Table 51
- Specifications 52
- Important Safety Information
- Regulatory Compliance
- Introduction
- Package Contents
- Your Projector
- Remote Control
- Powering/Charging the Projector
- Making Connections
- Using the Projector
- Bluetooth® Connections
- The Home Screen
- Using the Settings Menus
- Troubleshooting/FAQ
- Additional Information
- 20 -
Connecting to a Wi-Fi Network
To connect the projector to a wireless network:
1. Power on the projector. Refer to the Powering On/Off the Projector section on
page 17.
2. Select the Connectivity button on the home screen and press the enter ( ) button.
3. Select the Wi-Fi button on the Connectivity screen and press the enter ( ) button.
4. Select Wi-Fi in the Network menu and press the enter ( ) button.