Installation Notice
Table Of Contents
- Symbols Used 5
- General Safety Information 6
- Qumi Z1H Installation Notice 6
- Power Supply Safety 7
- Cleaning Qumi 7
- Control Warning 7
- FCC Warning 8
- Canada 8
- Safety Certifications 8
- Disposal and Recycling 8
- About this Manual 9
- Qumi Z1H Main Features 9
- Front-Left View 11
- Rear View 11
- Top View 12
- Bottom View 13
- Remote Control Keypad 14
- Activating the Remote Control Battery 15
- Replacing the Remote Control Battery 15
- Powering On/Off the Projector 17
- Connecting to a Wi-Fi Network 20
- Adjusting the Focus 23
- Playing Media Files from a Storage Device (USB Flash Drive, microSD Card) 24
- Screencasting with a Mobile Device 28
- Playing from a Video Source (HDMI) 29
- Playing from a Video Source (Type-C / DisplayPort) 30
- Viewing Documents from a Storage Device (USB Flash Drive, microSD Card) 31
- Using the Bluetooth® Speaker 33
- Connecting the Projector to Bluetooth Devices 35
- Customizing the App Shortcuts on the Home Screen 38
- Customizing the Category Menus 39
- The Projector Settings Menu 40
- The System Settings Menu 42
- Tips 46
- System Reset Method (Reboot) 46
- Image Problems 47
- Remote Control Problems 47
- Audio Problems 47
- FAQs 48
- Vivitek Support Site 49
- Projection Distance vs Projection Size 50
- Timing Mode Table 51
- Specifications 52
- Important Safety Information
- Regulatory Compliance
- Introduction
- Package Contents
- Your Projector
- Remote Control
- Powering/Charging the Projector
- Making Connections
- Using the Projector
- Bluetooth® Connections
- The Home Screen
- Using the Settings Menus
- Troubleshooting/FAQ
- Additional Information
- 15 -
Activating the Remote Control Battery
When using the remote control for the first time, the plastic sticker covering the battery
must be removed. To remove the plastic sticker, pull the tab at the bottom side of the
remote control to remove the plastic sticker from the battery compartment.
Replacing the Remote Control Battery
To replace the remote control battery:
1. Rotate the battery compartment cover
counter-clockwise so the line on the
cover points to the single dot on the
remote control.
2. Remove the battery compartment
cover.
3. Remove the old battery and replace it
with the new battery.
4. Place the battery compartment cover
back on the battery compartment and
rotate the cover clockwise so the line
on the cover points to the double
alignment dots.