Installation manual
MECHANICAL FIXING
Mark positions, drill holes and fit screws to wall, see diagram below.
Dimensions in millimetres.
Hang unit on screws and tighten.
TRUNKING OPTIONS
Connect unit to trunking (4" trunking min.) using up to five 32mm couplers. These are
pitched 48mm apart and centred 62mm from the wall. See diagram below.
OR
Cut notch
in trunking 250mm wide as shown in the diagram below. Remove the knockout
plate from the Tiger Power Unit underside and fit trunking to wall, butting up underneath the
Power Unit. Ensure all sharp edges are covered to prevent damage to cable insulation.
WALL
WALL
250
62
39
302
322
Use screws with minimum size No.8 x 1 1/2"
NOTE :
When positioning holes, take into account
that the unit will drop 10mm lower due to
the keyhole fixing slots
452
534
4
48 48 48 48
PLAN VIEW
PLAN VIEW
TRUNKING
TRUNKING
WARNING:
Allow 300mm top and at least 40mm side clearance
between the side flanges and any other object.
This unit must be mounted vertically.