User manual

Chapter 3 Examples
3-2
Step 4. In TP04G, choosing 1. download program TP04G PC. On TP04 screen, it will
show the words of “WAIT COMM…”.
Step 5. In TPEdit, choosing “Communication” > “Write Start figure to TP” and then press
“Yes” for confirmation. It will start to download to TP and it will display the progress
during download. Start figure can be downloaded without compiler.
Step 6. In TP04G, choosing “4. TP04G SETUP” > “8. START-UP DISPLAY” > “2. USER
DEFINE” as the following and you will finish the start-up display.
1. Download TP04G <-- PC
2. Upload TP04G --> PC
3. Copy TP04G <--> PC
. TP04G Settings
5. Execute
4
Start-up Display
1. TP04G Settings
2. User-defined
ENTER
5. Buzzer
6. Language Settings
7. Password Settings
. Start-up Display8
Note: You can set start-up display by yourself. But the picture must be monochromatic BMP
file and the Max. size should be 128X64. If you want to add text on it, the picture
should be smaller than 128X64 as shown in the following.
Example 2. To use TP04 to connect to two PLC and control their output contacts ON/OFF.
Step 1. Choose File（F
） to create a new file.