User manual

Chapter 2 Communication Connection Mode
2-1
Chapter 2 Communication Connection Mode
Before any communication between the TP and TPEdit software is conducted, the
user should complete the TP hardware settings and connect the correct wiring between
the two components.
There are three items in the communication protocol of TP series product that must be set
for communication to work properly.
■ The TP address and control port.
■ The RS-232 settings.
■ The RS-485 settings.
The software communication settings must also be set correctly to achieve proper
communication.
In the TPEdit software select “Tools” then “Communication Settings”. Enter the TP Station
Address, PC COM Port, and Baud Rate as shown in the following diagram.
After entering the correct settings, the PC is capable of communicating to the TP.
TP04G may connect to a PC by using cable DVPACAB530