User manual

Chapter 1 TPEdit Operation
1-52
Step 3. Click reference device to input device name, device number and
communication address. The devices’ name that you can set in this window are
X, Y, M, S, D, C and T and the equipment no. are 0~9.
Select the reference device (In the “Page Jump Condition Settings” dialog box,
it is different to set Bit or Value in condition Set. If you set to Bit, the device
name you can select are X, Y, M, S, C and T. If you set to Value, the device
name you can select are T, C and D. In dialog box of device reference, you can
check device name and select device name by clicking . If it is AC drive, you
don’t need to check device name. It will show $ to mean absolute address of
AC drive, input equipment no, communication address and then press Enter to
return to jump page set dialog box.
Step 4. In condition set, you could set Bit or Value. If you set it to Bit, it will jump to
designate page. If you set it to Value, you need to input value length, value type,
condition and operation condition. If the conditions are held, it will jump to the
designate page. If you just edit one page, the jump page will display 0 due to
the default first page is number 0.