User manual

Chapter 1 TPEdit Operation
1-42
Step 1. The setting steps are the same as ON/OFF button. There are some setting
items are different in the dialog box.
Step 2. The value length could be set to 16 bits or 32 bits. Value type could be
unsigned , signed, hexadecimal and BCD.
Step 3. If you set 3 for integer number and 2 for decimal number, the whole number
will be displayed as 000.00. If you set 5000 for the maximum value, the
maximum you could input is 050.00 due to there are 2 decimals. If you set
500 for the maximum value, the maximum you could input is 5.00.
Step 4. After finishing input, press OK to enter and the button will be used by the
function you set.
Constant: Pressing this button and TP will send the constant setting to PLC
corresponding register.