User manual

Chapter 1 TPEdit Operation
1-40
 Reset : Once you press this button and it will be always Off.
 Rising Pulse: pressing this contact to send the signal of rising-edge to the
PLC corresponding contact.
 Falling Pulse: pressing this contact one time to send the signal of falling-edge
to the PLC corresponding contact.
 Toggle On/Off: pressing the contact one time, the contact will be On and it will
be Off once you press the contact again.
 Momentary: the contact will be On when you press and hold on. Once you
release the button, the contact is Off.
Step 1. Choose Object (O) > Button and move the mouse to the editing area. At the
moment, the mouse pointer will be cross pointer. You could press the mouse
and hold on to drag, once you release the button the component will be
displayed.
Step 2. Double-click left button and you will get the following dialog box.
Step 3. Pressing
button at the right side of “Button Type” to select Set ON.
Step 4. Pressing button at the right side of “Write” to select the reference device
to write. And pressing button at the right side of “Read” to select the
reference device to read.
Step 5. Check Fun. Key and press to select one of F0~F9, Up, Down, Left, Right.
Please notice that function keys F5~F9 should be used with Shift key. You
should set it by yourself, if you don’t set it and you can’t control the button
component.
Step 6. User Level setting is used to protect this button. It should use with Tools (T) >
User-Level/Password Setting. If you set password for the button, you should
enter correct password before executing the button function.