User manual

Chapter 1 TPEdit Operation
1-38
■ Message Display
Step 1. Choose Object (O) > Message Display or click the button to get the
following dialog box. The settings of reference device, Total state, Current state,
device value >= range value setting are the same as the Dynamic Bitmap. The
max. Total state is 255 (Value) or 2 (Bit).
Step 2. TP will read the PLC corresponding contacts (ON or OFF) or register data and
display the corresponding status on TP screen. The content of message could
only be text and the text direction of LED message will be scrolls in a loop as
follows: from right to left, from left to right, from top to bottom and from bottom
to top.
Step 3. Choose View (V) > Object Inspector: display all properties of objects and it also
can be edited and set directly.
Step 4. it is used to set the arrangement order of the state of the corresponding device
(from max to min or from min to max)
Step 5. Double click the input cell of device value >=Range value to get the pop-up
dialog of all state table for user to set range value and edit message text.