User manual

Chapter 1 TPEdit Operation
1-34
Dynamic Bitmap: Choose Object (O) > Bitmap > dynamic bitmap or click the button .
TP reads PLC the corresponding contacts (ON or OFF) or register data value
will do comparison operation according to the corresponding base state. The
setting bitmap will be displayed on the screen according to the operation
result. (it you check bit, base state could be 0 or 1. If you check value, base
state could be set to 255)
Step 1. Choosing Object (O) > Bitmap > Dynamic Bitmap and then move the mouse to
the editing area. At the moment, the mouse pointer will be cross pointer and
you could press left button and hold on to drag. Once you release the button,
the action will be finished and the component will be displayed.
Step 2. You could move the mouse to this component and double-click the left button to
get the following dialog box.
Step 3. The settings of reference device, Total state, Current state, device value >=
range value setting are the same as the Multi-state Indicator. The Total state
could be set to 0~254. If you press BMP read, you will get the open dialog box.
You could set the corresponding bitmap for the current state. Each Current
state has the corresponding range value, if device value >= range value and it