User manual

Chapter 1 TPEdit Operation
1-32
value >= range value setting. You could set the corresponding bitmap for the
current state. Each current state has the corresponding range value, if device
value >= range value and it will show the corresponding bitmap. For example,
if current state 0 and range value is 300, current state 1 and range value is 500,
when device value is between 300, 500 and it will show the corresponding
bitmap of current state 0, if device value is large than 500, and it will show the
corresponding bitmap of current state 1. But if device value is small than 300, it
won’t display any bitmap due to no current state conforms to it.
Step 3. Choose View (V) > Object Inspector: display all properties of objects and it also
can be edited and set directly.
Step 4. it is used to set the arrangement order of the state of the corresponding device
(from max to min or from min to max)
Step 5. Double click the input cell of device value >=Range value to get the pop-up
dialog of all state table for user to set.
Step 6. “Refer Value” can be used to calculate state range.
■ Bitmap
You could choose static bitmap or dynamic bitmap.
Static Bitmap: choose Object (O) > Bitmap > Static Bitmap or click the button . It will
read the static bitmap to be the background of TP. It just can read the
file with extension .bmp now.
Step 1. Choose Object (O) > Bitmap > Static Bitmap and move the mouse to the editing
area. At the moment, the mouse pointer will be cross pointer. Pressing the left
button and hold on to drag, once you release the button the action will be
finished. The component will be shown.
Step 2. Moving the mouse on this component and double-click the left button. You will