User manual

Chapter 1 TPEdit Operation
1-31
■ Indicator(16x16)
There are two types for you to choose:
Indicator: Choose Object (O) > Indicator(16x16) > Indicator or click the button to
set. When TP reads the PLC corresponding contacts (ON or OFF), it will
show the corresponding figure.
Multi-state Indicator: choose Object (O) > Indicator(16x16) > Multi-state Indicator or
click the button to set.
Step 1. Choose Object (O) > Indicator(16x16) > Multi-state Indicator. If you set as the
following dialog box, When the device value >= 300, current state is 0 and the
bitmap will display . There are five indications from 0 to 4.
Step 2. The settings of, Current state 0~4, bitmap set, set display sequence and device