System information

Chapter 4 Communication Connection Mode
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
4-1
Chapter 4 Communication Connection Mode
Before any communication between the TP and TPEdit software is conducted, the
user should complete the TP04G hardware settings and connect the correct wiring
between the two components.
There are three items in the communication protocol of TP series product that must be set
for communication to work properly.
!
The TP address and control port.
!
The RS-232 settings.
!
The RS-485 settings.
The software communication settings must also be set correctly to achieve proper
communication.
In the TPEdit software select “Settings” then “Communication Protocol”. Enter the TP
address, communication port, communication speed, data bit, parity check and stop bit as
shown in the following diagram.
After entering the correct settings, the PC is capable of communicating to the TP04G.
~Using connection cable DVPACAB515
1
5
6
9
9 PIN D-SUB
PC TP04G
ON PC (RS-232)
ON TP04G
5
1
9
6
9 PIN D-SUB
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
RX
TX
RX
TX
GND