System information

Chapter 3 TPEdit Software Operation

3-36

Step 8. Font is used to set the text on the button. Its size is usually set to 8X12. You

could also select figure to put on button. You could select no frame, single

frame, double frame, circle frame and hidden for the button. If you select

hidden, the button won’t have any frame on the HMI page but it still has the

same function when executing.

Step 9. After setting and press OK, the button will be used according to the setting

function.

Complex Button: press this button and HMI will send the signal to the PLC

corresponding contact or register. The signal could be cycle through

S1 S2 S3 S4 S0 or S0 S4

S2 S1 S0. The max. state could be 256 (VALUE),

16 (LSB) and 2 (BIT).

Input button: Press this button and HMI will display built-in value on screen. You could

use function key or common key to enter value. When pressing Enter,

HMI will send value to PLC corresponding register.

Step 1. The setting steps are the same as ON/OFF button. There are some setting

items are different in the dialog box.

Step 2. The value length could be set to 16 bits or 32 bits. Value type could be

unsigned decimal, signed decimal, hexadecimal and BCD.

Step 3. If you set 3 for integer number and 2 for decimal number, the whole number

will be displayed as 000.00. If you set 5000 for the maximum value, the

maximum you could input is 050.00 due to there are 2 decimals. If you set 500

for the maximum value, the maximum you could input is 5.00.

Step 4. After finishing input, press OK to enter and the button will be used by the

function you set.

Setting constant button:

pressing this button and HMI will send the constant setting

to PLC corresponding register.