System information

Chapter 3 TPEdit Software Operation
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
3-34
!
Message Display
Step 1. Choose Object (O
) > Message Show or click the button to get the
following dialog box.
Step 2. HMI will read the PLC corresponding contacts (ON or OFF) or register data
and display the corresponding status on HMI screen. The content of message
could only be text and the text direction of LED message will be scrolls in a
loop as follows: from right to left, from left to right, from top to bottom and from
bottom to top.
Step 3. The max. base state is 255 (Value) or 2 (Bit).
!
Button
TPEdit provides a series of button for user to use in every kind of occasion. That will
save much time in designing PLC program. Choose Object (O
) > Button or click the
button
to get the following dialog box. The following is the introduction for the
buttons.
ON/OFF button: press this button and HMI will send the contact signal to the PLC
corresponding contact ON or OFF. There are 6 types of ON/OFF
buttons.
$
ON button: Once you press this button and it will be always ON.
$
OFF button: Once you press this button and it will be always OFF.
$
Pulse ON: pressing this contact to send the signal of rising-edge to the PLC
corresponding contact.
$ Pulse OFF: pressing this contact one time to send the signal of falling-edge
to the PLC corresponding contact.
$ Interactive: pressing the contact one time, the contact will be ON and it will
be OFF once you press the contact again.