System information

Chapter 3 TPEdit Software Operation

3-31

Step 1. Choosing Object (O) > Figure > Dynamic figure and then move the mouse to

the editing area. At the moment, the mouse pointer will be cross pointer and

you could press left button and hold on to drag. Once you release the button,

the action will be finished and the component

will be displayed.

Step 2. You could move the mouse to this component and double-click the left button

to get the following dialog box.

Step 3. The settings of reference device, base state, range number are the same as

the range light setting. The base state could be set to 0~254. If you press

BMP read, you will get the open dialog box. You could set the corresponding

picture for the base state. Each base state has the corresponding range value,

if device value >= range value and it will show the corresponding picture. For

example, if base state 0 and range value is 100, base state 1 and range value

is 300, when device value is between 100, 300 and it will show the

corresponding picture of base state 0, if device value is large than 300, and it

will show the corresponding picture of base state 1. But if device value is small

than 100, it won’t display any picture due to no base state conforms to it.

Scale

Step 1. Choose Object (O

) > Scale or click the button to get the following dialog.