System information

Chapter 3 TPEdit Software Operation

3-20

Step 3. Click reference device to input device name, device number and

communication address. The devices’ name that you can set in this window

are X, Y, M, S, D, C and T and the equipment no. are 0~F.

Select the reference device (In the “Jump Page Set” dialog box, it is different to set Bit

or Value in condition Set. If you set to Bit, the device name you can select are X, Y, M,

S, C and T. If you set to Value, the device name you can select are T, C and D. In

dialog box of device reference, you can check device name and select device name

by clicking

. If it is AC drive, you don’t need to check device name. It will show $ to

mean absolute address of AC drive, input equipment no, communication address and

then press Enter to return to jump page set dialog box.

Step 4. In condition set, you could set Bit or Value. If you set it to Bit, it will jump to

designate page. If you set it to Value, you need to input value length, value

type, condition and operation condition. If the conditions are held, it will jump

to the designate page. If you just edit one page, the jump page will display 0