System information

Chapter 2 TP04G Operation and Settings
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
2-5
TP04G Settings
1. Communication address 001
2. PLC Control Port RS232
Communication Protocol
1. TP04G Settings
2. RS232
3. RS485
ENTER
!
Communication Address: Users may use the left, right, F0-F4 and Shift F0-F4
keys to change the value of communication address. The left and right keys are
used to choose the integer location, and the F0-F4 keys are used to select a
value of the integer. Example: if F2 is pressed, a value of 2 is placed in the
integer location the curser is displaying. The address may be set from 0~255. If
the value set exceeds this range, the unit will reset the address to 001. After the
Communication Address has been set, press the “Esc” key to go back to the
TP04G settings screen.
!
PLC Control Port: Users may choose RS232 or RS485 as the control port. To
set the PLC control port, use the Left or Right arrow to toggle between RS232 or
RS485 and press Enter.
TP04G Settings
1. Communication address 001
. PLC Control Port RS2322
TP04G Settings
1. Communication address 001
2. PLC Control Port RS485
ENTER
B. RS232
!
The RS232 Protocol parameters may be set to meet the needs of the connected
hardware. The Transmission Baud rate, Data Length, Parity check, and Stop Bit
are all programmable using the Left and Right arrows and scrolling through the
available options.
Communication Protocol
1. TP04G Settings
. RS232
3. RS485
2
1. Transmission Rate 9600
2. Data Length 7-bit
3. Parity Check Even
4. Stop Bit 1-bit
RS232
ENTER
!
Transmission Rate: The Left or Right arrow will scroll from 9600 to 19200 or
38400. When complete press the Enter key.
1. Transmission Rate
2. Data Length 7-bit
3. Parity Check Even
4. Stop Bit 1-bit
19200
RS232
ENTER
1. Transmission Rate 9600
2. Data Length 7-bit
3. Parity Check Even
4. Stop Bit 1-bit
RS232
< >
!
Data Length: The Left or Right arrow will toggle between 7-bit or 8 bit. When
complete press the Enter key.