Datasheet

DS_SD02S/D_03152012 E-mail: [e-mail]
http://www.delta.com.tw/dcdc
Power Derating Curve
Output Power (%)
Notes
1 Specifications typical at Ta=+25℃, resistive load, nominal input voltage and rated output current unless otherwise noted.
2 Transient recovery time is measured to within 1% error band for a step change in output load of 75% to 100%
3 Ripple & Noise measurement bandwidth is 0-20MHz.
4 These power converters require a minimum output loading to maintain specified regulation, operation under no-load conditions will not
damage these modules; however they may not meet all specifications listed.
5 All DC/DC converters should be externally fused at the front end for protection.
6 Specifications subject to change without notice.
7 It is not recommended to use water-washing process on SMT units.
Mechancial Drawing
Mechanical Dimensions Connecting Pin Patterns
►All dimensions in mm (inches)
►Tolerance: X.X±0.25 (X.XX±0.01)
X.XX±0.13 ( X.XXX±0.005)
►Pins ±0.05 (±0.002)
Pin Connections Physical Outline
Pin Single Output Dual Output Case Size : 24.0x13.7x8.0mm (0.94x0.54x0.31 Inches)
1 -Vin -Vin Case Material Non-Conductive Black Plastic
7 NC NC : (flammability to UL 94V-0 rated)
8 NC Common Weight : 5.1g
9 +Vout +Vout
10 -Vout -Vout
16 +Vin +Vin
NC : No Connection
P3
24.0 [0.94]
13.7 [0.54] 18.1 [0.71]
15.24 [0.6]
[0.1]
[0.12]
2.54
3.11
1.00 [0.04]
1
78
10
9
16
8.0 [0.31]
0.25 [0.01]
0
~
4
8.25 0.5
[0.32 0.02]
S SEATING
PLANE
0.15 S
2.8mm
15.24mm
19.3mm
2.54mm
13.7mm
17.78mm
1.4mm(Min)