User's Manual

Doc #: 1ANSU-160004
DNI SGDC-D22 User Manual
i. 17
Figure 11, Change Dial Number.
After confirm the APN and the dial number, use the following command to connect a 3G service.
# 3g-connect
You also can get RSSI value and reflash the signal strength led status by using the following command.
# get-rssi-ber
To get imsi code, use the command below.
# getimsi
Use the command below to disconnect the 3G service.
# 3g-disconnect
6.4. PPPoE over eth0
To access Internet via the service form your ISP, e.g. ADSL, you can use PPPoE to connect to your ISP. Before using
PPPoE, you need to request your ISP to setup an ADSL modem in your house and get some information, e.g.
username and password, which is needed on setting your connection.