Specifications

Application Note
Using Verizon IP Trunk Services with the HiPath 3000 V9 system
Page 40 of 55
11 HiPath 3000 Configuration – Verizon IP Trunks
This section will outline the steps for the Configuration of the Verizon SIP Trunks with the HiPath
3000 Version 9 system. The configuration requires the creation or modification of the database
within the HiPath 3000 system and the HG1500 VoIP Interface card.
The documented steps assume that the system administrator is a certified technician on the
HiPath 3000 platform.
The configuration information assumes that the system connection to the Internet using LAN Port
1 on the HG1500 card has been established.
11.1 Configure the HiPath 3000 System Information
This section will provide the configuration steps for programming the HiPath 3000 system
11.1.1 Transfer database to the Manager E tool from the system
After completing the programming for the HG1500 card, using the Manager E tool, transfer a new
database from the system to the Manager E tool. Select File > Transfer to access the File transfer form.
Enter the IP address of the HiPath 3000 system and select the System > PC option.
11.1.2 Configure the system Parameters
Under the system parameters > Flags menu insure that the following flags are enabled
11.1.3 Configure the Trunk Route Settings
Under the Lines and Networking > Routes menu select Trunk Grp. 12 and change the name of the Route
to Verizon.
Press the Apply button after making the changes