DFWM-GIN01-DT0R User Manual DFWM-GIN01-DT0R An IEEE 802.11b/g/n Low-Power Wireless System-On-Chip module User Manual Sheet 1 of 18 July.
DFWM-GIN01-DT0R This document describes a simple method for characterizing DFWM-GIN01-DT0R WLAN module based RF parameters, such as transmitted spectra and receiver sensitivity. It will be described step by step below that how to control and setup. Step 1 : Extract to CDM20814_WHQL_Certified.zip, it is a USB to UART driver, then setup it. Step 2 : Setup teraterm_utf8-4.58.exe program, this program can help to send command to module.
DFWM-GIN01-DT0R Step 6 : Now any legal command can be keyed in and if UTF-8 reply ok, the command is implemented successful like below figure. Figure 3 802.
DFWM-GIN01-DT0R at+wrfteststart at+wtx100test=1,0,9,0,0,0,0,1,1,0,0,1,1,1 at+wtx100test=6,0,9,0,0,0,0,1,1,0,0,1,1,1 at+wtx100test=11,0,9,0,0,0,0,1,1,0,0,1,1,1 At+reset Start up internal Power Amplifier Continuous Tx Channel 1, 2Mbps Continuous Tx Channel 6, 2Mbps Continuous Tx Channel 11, 2Mbps Transmitter off Transmitted Tx at 1Mbps at+wrfteststart at+wtx100test=1,0,18,0,0,0,0,1,1,0,0,1,0,1 at+wtx100test=6,0,18,0,0,0,0,1,1,0,0,1,0,1 at+wtx100test=11,0,18,0,0,0,0,1,1,0,0,1,0,1 At+reset Start up internal
DFWM-GIN01-DT0R at+wtx100test=1,0,26,0,0,0,0,1,0,0,0,1,1,0 at+wtx100test=6,0,26,0,0,0,0,1,0,0,0,1,1,0 at+wtx100test=11,0,26,0,0,0,0,1,0,0,0,1,1,0 At+reset Continuous Tx Channel 1, 24Mbps Continuous Tx Channel 6, 24Mbps Continuous Tx Channel 11, 24Mbps Transmitter off Transmitted Tx at 18Mbps Command at+wrfteststart at+wtx100test=1,0,27,0,0,0,0,1,0,0,0,1,6,0 at+wtx100test=6,0,27,0,0,0,0,1,0,0,0,1,6,0 at+wtx100test=11,0,27,0,0,0,0,1,0,0,0,1,6,0 At+reset Action Start up internal Power Amplifier Continuous T
DFWM-GIN01-DT0R at+wtx100test=1,0,18,0,0,0,0,1,0,0,0,1,7,2 at+wtx100test=6,0,18,0,0,0,0,1,0,0,0,1,7,2 at+wtx100test=11,0,18,0,0,0,0,1,0,0,0,1,7,2 At+reset Continuous Tx Channel 1, 72Mbps Continuous Tx Channel 6, 72Mbps Continuous Tx Channel 11, 72Mbps Transmitter off Transmitted Tx at MCS6 at+wrfteststart at+wtx100test=1,0,20,0,0,0,0,1,0,0,0,1,6,2 at+wtx100test=6,0,20,0,0,0,0,1,0,0,0,1,6,2 at+wtx100test=11,0,20,0,0,0,0,1,0,0,0,1,6,2 At+reset Start up internal Power Amplifier Continuous Tx Channel 1, 65Mb
DFWM-GIN01-DT0R Transmitted Tx at MCS1 at+wrfteststart at+wtx100test=1,0,27,0,0,0,0,1,0,0,0,1,1,2 at+wtx100test=6,0,27,0,0,0,0,1,0,0,0,1,1,2 at+wtx100test=11,0,27,0,0,0,0,1,0,0,0,1,1,2 At+reset Start up internal Power Amplifier Continuous Tx Channel 1, 14.4Mbps Continuous Tx Channel 6, 14.4Mbps Continuous Tx Channel 11, 14.
DFWM-GIN01-DT0R Device Pin-out Diagram (Module top view) User Manual Sheet 8 of 18 July.
DFWM-GIN01-DT0R DFWM-GIB0x Device Pin-out Diagram (Module top view) Module Pins Description User Manual Sheet 9 of 18 July.
DFWM-GIN01-DT0R User Manual Sheet 10 of 18 July.
DFWM-GIN01-DT0R User Manual Sheet 11 of 18 July.
DFWM-GIN01-DT0R User Manual Sheet 12 of 18 July.
DFWM-GIN01-DT0R Antenna Information RFA-02-P33-70B-150 Frequency 2400 MHz – 2500 MHz range Peak gain 2 dBi Average 1 dBi gain VSWR 2.0 : 1 Max. Radiated pattern RFA-02-L2H1 2400 MHz – 2500 MHz 2.5 dBi 2.0 : 1 Max. H-Plane V-Plane User Manual Sheet 13 of 18 July.
DFWM-GIN01-DT0R Location include User Manual Sheet 14 of 18 July.
DFWM-GIN01-DT0R Canada, Industry Canada (IC) Notices This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. Operation is subject to the following two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Radio Frequency (RF) Exposure Information The radiated output power of the frequency exposure limits.
DFWM-GIN01-DT0R Canada, avis d'Industry Canada (IC) Cet appareil et RSS-210. numérique de classe B est conforme aux normes canadiennes ICES-003 Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d'interférence et (2) cet appareil doit accepter toute interférence, notamment les interférences qui peuvent affecter son fonctionnement.
DFWM-GIN01-DT0R Federal Communications Commission (FCC) Statement You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Section 15.
DFWM-GIN01-DT0R -Consult the dealer or an experienced radio/TV technician for help. Part 15.19(a)(3) unlicensed project (WLAN Device) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation of the device.
