User's Manual

Step 2:
Setup via Ethernet Cable
System configuration shown as below
Please make sure your PC can access the internet.
Please make sure AP/Router has enable the DHCP service.
On Data Collector OLED Display
Choose ETHERNET DEVICE ( DOWN -> SELECT)
After a while, the IP address will be shown on Data Collector OLED Display.
(This IP address is assigned by the AP/Router.)
In Your PC Side
Open the web browser, key-in IP address as shown on the Data Collector OLED Display.
192.168.X.X
TTL ENERGY: XX.XkWh
> Wi-Fi DEVICE
> ETHERNET DEVICE