User's Manual

2. DDP Installation

Preparation

Before you install this device, first please check if the following items are included

in the DDP package box. If there is any item missing, please contact your dealer

for a free replacement:

z DDP Communications

z Ethernet cable

z Wi-Fi antenna

z AC power cord

z A kit of conical anchors and screws

z Wall bracket

z User manual

The following networking environment is required for install DDP:

z A reliable broadband internet connection

z Web browser to view DELTA Solar EMS webpage

z Router / LAN or Router/WLAN with Ethernet port (or AP Router with Wi-Fi

connection)

z Grid connected standard AC electrical outlet. Please do not plug DDP into a

transformer protection device like a power strip, surge protector, or

un-interruptible power supply. These devices could block the

communication signal.

Installation

Pick a suitable location to place your DDP device. We suggest this location to be as

close as possible to the wireless AP (if you have the Wi-Fi function) or the Service

Panel (Load center). This DDP is designed to perform at an environment between

-10 degrees C to +40 degrees C that should cover the majority of indoor

environments.

Attention

Please call the installer if you have below conditions:

1. You are unable to understand how it works.

2. You notice any operation anomalies.

3. You don’t understand or fear that you can’t complete the fully install

steps.

4. This device must be installed in rooms with suitable environmental

conditions (see technical data).

DO NOT install outdoors.