User's Manual

16
You can press “MENU” button back to menus or back to power information after 30
second timeout.
You will see the WiFi signal strength display on LCD as bellow:
If your AP router has logo and use the WiFi to be transmitter, it also can
use the WPS function to do quick communicate with AP router. It just only can
support the security above WPA mode, such as WPA, WPA2…etc. (It can’t
support WEP serials.)
It will display the “WPS EXCUTION PLEASE WAIT…” if user presses the “WPS
START”.
Please press the WPS button on the AP router (you can refer AP router manual to
find it), then AP router indicator will blinking and start to find the device which
want to connect each other.
It will cost about 30 seconds to connect and get new IP if it connects successful.
The success message will display as below:
It will reconnect 3 times if AP router blinking doesn’t dark and find any devices. So,
it will cost almost 1’30 seconds. The “CONNECT FAIL” message display as below
if it also can’t find any devices. Press “MENU” and then press “ENTER”, you also
can do WPS again.
It will display as below message as you press “WPS START” function again if you
have already connected successful.
192.168.xxx.xxx Web
ID: 1 POWER:123.4W
WPS EXCUTION
PLEASE WAIT…
CONNECT SUCCESS
PRESS ‘MENU’ BAC
K
CONNECT FAIL
PRESS ‘MENU’ BAC
K