User's Manual

15
The other has no above menus if user choices Ethernet to be transmitter.
If you choose the wrong one or want to change the transmit device, you can go
into the “SYSTEM RESET” item and then display confirm message “RESET
DEVICE?” It will return to select the transmit device menu again by pressing
“SELECT”. Note, it will also clear all the setting after pressing. You can return to
original menu if you press “MENU”. It does not affect the PLC data of the memory
but system data of DDP will return to default. So, it will display power information
if you register EMS again.
The WiFi signal strength detect between DDP with AP router if user press “RSSI
DETECT”. It will display “SCANNING…” if you have already connected with AP and
press it.
Otherwise, it will display “SCAN CAN’T WORK PLEASE CONNECT AP” message if
user don’t connect with AP first.
It will take few seconds (less than 1 min) to detect DDP with AP router signal
strength. Then, it will display “SCANNING FINISH PRESS ’MENU’ BACK” message
to indicate the scan function has finished.
RESET DEVICE?
MENU:NO SELECT:YES
SCANNING…
SCANNING FINISH
PRESS ‘MENU’ BAC
K
SYSTEM RESET
EXIT MENU
SCAN CAN’T WORK
PLEASE CONNECT AP