User's Manual

11
3. DDP Operation
Starting the DDP
After plugging the power cord, you will see the “Wi-Fi DEVICE” and “ETHERNET
DEVICE” message display on the LCD of the DDP. It requires you to choose one
device to be the data transmitter. If you do not have an AP router or Wi-Fi function,
you only can choose the “ETHERNET DEVICE” option. Otherwise, the device will
not operate.
After the initial setup, the system restores the default value or user setting. It will
then display the IP address and Power in watts on the LCD after initializing is
finished.
The LCD display will then change to become a calendar with power information
after 10 sec.
Attention
If you do not choose a valid device, the display will remain on the device
choice menu. The OLED fonts will disappear after user selects a device. If you
would like to choose another transmitter again, you can select the “SYSTEM
RESET” function of the menu or “Reset Button” of the slot to go to the initial step.
Wi-Fi operates at a frequency of 2.4GHz that follows the IEEE802.11b/g
communication standard. The 802.11g has a maximum raw data rate of 54Mbits/s
and data access rate as defined in 802.11g. Sometimes, the RF signal decay or
interference will be caused the data lose or DDP disconnection. So, please find
the places which no interference or decay to let RF signal stable and strong. For
WiFi compatible list, please refer the WiFi supplier web site.
169.254.0.1
ID: 1 POWER:123.4W
> Wi-Fi DEVICE
ETHERNET DEVICE
00/00/00 00:00:00
ID: 1 POWER:123.4W