FEDERAL COMMUNICATIONS COMMISSION NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
INTRODUCTION Our monitors is high resolution color mentors for use with IBM PC/XT/AT and PS/2 computers or compatibles with analog RGB output. The monitors support timings of graphics adapters including: VGA, super VGA, XGA, 1024 x 788 and 1280 x 1024. FEATURES Automatically scan horizontal and vertical frequencies. Analog input signal provides the capability of unlimited display colors. Auto sizing and auto centering between modes of graphics standards.
Be sure fo turn off the AC Power to the monitor before making connections 3. Conmnect the end of the signal cable to the display connector of computer 1.Assemble the tilt/swivel base as shown below. 2.Connect the power cord as shown on page 8. CAUTION: and tighten the screws as shown on page 8.
USING THE RIGHT POWER CORD FOR 230VAC For units used at 120V:Use a UL Listed cord set consisting of a minimum NO.18 AWG. Type SVT or SJT, rated SA minimum 125V, three-conductor cord a maximum length and a parallel blade, grounding type attachment plug. For units used at 230V (domestic use): Use a UL Listed cord set consisting of a minimum No. 18 AWG, Type SVT or SJT, rated 3A minimum 250V, three conductor cord a maximum length and a tandem lade. grounding type attachment plug.
1. TILT/SWIVEL BASE Tum the monitor for comfortable viewing angle within 180 degrees houri zonally and 20 degrees vertically. (Please refer to instructions on bottom of rear cover for installation.) 2. SIGNAL INPUT CONNECTOR (15-pin mini D-SUB) Connect to the display adapter output of a computer having analog video output. (Please see installation instructions.) 3. AC INPUT CONNECTOR (Appliance couplet) Connect to AC outlet with supplied power cord. 4.
OSD MANUAL VOLUME (AUDIO MODEL ONLY) BASIC HORIZONTAL SIZE + HORIZONTAL POSITION + VERTICAL SIZE + VERTICAL POSITION « DEGASSED © V-MOIRE GEOMETRY + PINCUSHION TRAPEZOID + PARALLEL + ROTATION COLOR + 9300K / 6500K + RGB STATUS RECALL + BASIC & GEOMETRY + COLOR EXIT NOTE: © To enter OSD : Push * MENU ” bottom. To exit OSD: 1. Push * MENU two keys simultaneous or 2. Select " exit * and push an adjusting button At default state (screen without OSGOOD, * + * buttons function as contrast or Brightness control.
POWER MANAGEMENT THIS MONITOR CAN SUPPORT VASE POWER MANAGEMENT SYSTEM, INDICATED BY THE LED ON THE FRONT PANEL: STATE LED POWER COLOR CONSUMPTION ON GREEN 100W STANDBY/ AMBER < 15W SUSPEND ACTIVE OFF AMBER < §W The monitor remains in the power-saving state until you press a key on the keyboard or move the mouse (if available}. DISPLAY DATA CHANNEL (DDC) COMMUNICATION CHANNEL TYPE: VASE DDC1/2B ESTABLISHED TIMINGS: AS PRESET TIMING CHARTS.
