User manual

ASDA-A User Manual Chapter 4 Display and Operation

4-3

4-3 Status Display

4-3-1 Save Setting Display

After the Set key is pressed, LCD display will show the following display messages for approx. one second

according to different status.

Display Message Description

The setting value is saved correctly.

Read only. Write-protected.

Invalid password or no password input

The setting value is error or input reserve setting value.

Servo system is running and it is unable to input.

This parameter will not be stored in EEPROM.

This parameter is valid after restarting the drive.

4-3-2 Abort Setting Display

Display Message Description

In parameter mode, press Mode key to abort parameter setting.

In setting mode, pressing Mode key can return back to parameter mode.

After returning back to parameter mode, press Mode key again can abort

parameter setting.

4-3-3 Fault Message Display

Display Message Description

When the AC servo drive has a fault, LCD display will display “ALEnn”.

“ALE” indicates the alarm and “nn” indicates the alarm code. The display

range of alarm code “nn” is 1 to 22. For the information of fault code,

please refer to parameter P0-01.

4-3-4 Positive/Negative Symbol Setting Display

Display Message Description

When entering into setting mode, pressing UP or DOWN arrow key can

increase/decrease the display value. SHIFT key is used to change the

selected digit (The selected digit will blink).